1.75" (45mm) Primaries - 2 into 1 Merge collector Jig
3d Printed fabrication Jig allows for easy cutting of mandrel bent tubes to form each side of the merge collector. The outlet circumference is matched to allow easy fit up of outlet tube. Recommended cut using a vertical bandsaw for best results (avoid abrasive cutting tools as the plastic will melt. Alternately use the jig to mark the tube then remove and cut with an angle grinder).
Specific Sizes:
Suits 45mm OD, 1.5 x D CLR, 15 degree Mandrel Bends
Inlet size: 1.75” (45mm)
Outlet size: 2” (50.8mm)
Bolt size: M8 Cap head (Not included)
3d Printed fabrication Jig allows for easy cutting of mandrel bent tubes to form each side of the merge collector. The outlet circumference is matched to allow easy fit up of outlet tube. Recommended cut using a vertical bandsaw for best results (avoid abrasive cutting tools as the plastic will melt. Alternately use the jig to mark the tube then remove and cut with an angle grinder).
Specific Sizes:
Suits 45mm OD, 1.5 x D CLR, 15 degree Mandrel Bends
Inlet size: 1.75” (45mm)
Outlet size: 2” (50.8mm)
Bolt size: M8 Cap head (Not included)
3d Printed fabrication Jig allows for easy cutting of mandrel bent tubes to form each side of the merge collector. The outlet circumference is matched to allow easy fit up of outlet tube. Recommended cut using a vertical bandsaw for best results (avoid abrasive cutting tools as the plastic will melt. Alternately use the jig to mark the tube then remove and cut with an angle grinder).
Specific Sizes:
Suits 45mm OD, 1.5 x D CLR, 15 degree Mandrel Bends
Inlet size: 1.75” (45mm)
Outlet size: 2” (50.8mm)
Bolt size: M8 Cap head (Not included)